Skip links
Makuri Materials

We specialize in the development, testing and use of the best and most appropriate materials to deliver new benchmark setting results under the most arduous of conditions.

All materials are tested and developed for use in the complex mix of extreme impact and abrasion applications as found in hard rock mining and have been proven to be market leaders in delivering the lowest Total Cost of Ownership.

New materials development is assessed in house and by using independent laboratories then typically with selected participating “early adopter” end users. This is done across both the mobile and process wear application areas with and without the use of Partner Agreements.

The materials groups covered here show the range and application to not only meet lowest TCO but also significantly reduce carbon footprint.

Contact Us for a discussion about the right products to suit your application.

Disclaimer: all grades shown are nominal grades only and subject to change without notice.

Cast Manganese Crusher Liners

Cast Alloy Crusher & Chute Liners

Bi-Metallic Wear Plates & Blocks

Ceramic Wear Liners for chute applications

Hard Facing and Joining wire

Chrome Titanium XAB is a tubular Hard Facing wire filled with Chrome and Titanium Carbides for use in eXtreme ABrasion (XAB) applications where hard facing of dissimilar metals is required. It can be used without pre-heat or use of shielding gases. Can be used to hard face over, protect and join the installation welds on wear blocks, wear plates and metallic liners of all types.

Only the best materials allow for superior results